cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1811
Views
0
Helpful
3
Replies

MPLS ATOM: Can not get imposition rewrite string

klausschneider
Level 1
Level 1

I´ve got this message when configuring a vpls between c7206(ios15) and 3750me, below follows my config:

CE===(f1/0/2)c3750 (f1/0/1)=====(g0/1.100)c7206(g0/2.101)===CE

c3750:

!

system mtu routing 1500

!

interface Loopback0

ip address 1.1.1.1 255.255.255.255

ip ospf network point-to-point

!

...

!

interface FastEthernet1/0/1

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 100

switchport mode trunk

!

interface FastEthernet1/0/2

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 101

switchport mode trunk

!

...

!

interface Vlan100

ip address 10.0.0.1 255.255.255.0

mpls label protocol ldp

mpls ip

!

interface Vlan101

no ip address

xconnect 2.2.2.2 666 encapsulation mpls

!

router ospf 100

router-id 1.1.1.1

log-adjacency-changes

network 1.1.1.1 0.0.0.0 area 0

network 10.0.0.0 0.0.0.255 area 0

!

mpls ldp router-id Loopback0 force

c7206:

interface GigabitEthernet0/1.100

encapsulation dot1Q 100

ip address 10.0.0.2 255.255.255.0

no snmp trap link-status

ip ospf mtu-ignore

mpls ip

!

interface GigabitEthernet0/2.101

encapsulation dot1Q 101

no snmp trap link-status

no cdp enable

xconnect 1.1.1.1 666 encapsulation mpls

!

interface Loopback1

ip address 2.2.2.2 255.255.255.255

ip ospf network point-to-point

!

router ospf 100

log-adjacency-changes

network 2.2.2.2 0.0.0.0 area 0

network 10.0.0.0 0.0.0.255 area 0

!

mpls ldp router-id Loopback1 force

c3750#sh mpls l2transport vc det

Local interface: Vl101 up, line protocol up, Eth VLAN 101 up

  Destination address: 2.2.2.2, VC ID: 666, VC status: down

    Output interface: if-?(0), imposed label stack {}

    Preferred path: not configured 

    Default path: active

    Next hop: Invalid MOI

  Create time: 00:52:45, last status change time: 00:00:04

  Signaling protocol: LDP, peer 2.2.2.2:0 up

    MPLS VC labels: local unassigned, remote 18

    Group ID: local unknown, remote 0

    MTU: local unknown, remote 1500

    Remote interface description:

  Sequencing: receive disabled, send disabled

  VC statistics:

    packet totals: receive 0, send 0

    byte totals:   receive 0, send 0

    packet drops:  receive 0, send 0

c3750# sh logg

00:54:11: %LDP-5-NBRCHG: LDP Neighbor 2.2.2.2:0 (1) is UP

00:54:17: ATOM: Can not get imposition rewrite string

00:54:33: ATOM: Can not get imposition rewrite string

00:54:36: tagcon: background scan: Start

00:54:36: tagcon: background scan: End

00:54:40: %LDP-5-CLEAR_NBRS: Clear LDP neighbors (*) by vty0 (10.0.0.2)

00:54:40: %LDP-5-NBRCHG: LDP Neighbor 2.2.2.2:0 (1) is DOWN (User cleared session manually)

00:54:40: AToM MGR [2.2.2.2, 666]: Delete remote vc label binding

00:54:40: AToM MGR [2.2.2.2, 666]: Update local vc label binding

00:54:45: %LDP-5-NBRCHG: LDP Neighbor 2.2.2.2:0 (2) is UP

00:54:45: AToM MGR [2.2.2.2, 666]: Advertise local vc label binding

00:54:45: AToM MGR [2.2.2.2, 666]: Remote end up, inst 2

00:54:45: AToM MGR [2.2.2.2, 666]: Validate vc, activating data plane

00:54:45: AToM MGR [2.2.2.2, 666]: Receive SSM dataplane up notification

00:54:45: AToM MGR [2.2.2.2, 666]: Dataplane activated

00:54:45: AToM MGR [2.2.2.2, 666]: Remote end down, vc is down

00:54:45: AToM MGR [2.2.2.2, 666]: Unprovision SSM segment

00:54:45: AToM MGR [2.2.2.2, 666]: Remote end up, inst 2

00:54:45: AToM MGR [2.2.2.2, 666]: Validate vc, activating data plane

00:54:45: AToM MGR [2.2.2.2, 666]: Receive SSM dataplane up notification

00:54:45: AToM MGR [2.2.2.2, 666]: Dataplane activated

00:54:47: ldp: ldp start; tbl 0

00:54:48: ATOM: Can not get imposition rewrite string

00:54:48: AToM MGR [2.2.2.2, 666]: Local end down, vc is down

00:54:48: AToM MGR [2.2.2.2, 666]: Unprovision SSM segment

00:54:48: AToM MGR [2.2.2.2, 666]: Label 18 free for reuse in 201 sec

00:54:48: AToM MGR [2.2.2.2, 666]: Label 18 released while on hold, reduce hold time to 21 sec

c7206#sh mpls l2transport vc det

Local interface: Gi0/2.101 up, line protocol up, Eth VLAN 101 up

  Destination address: 1.1.1.1, VC ID: 666, VC status: down

    LFIB entry present

    Output interface: unknown, imposed label stack {}

  Create time: 01:01:06, last status change time: 00:00:09

  Signaling protocol: LDP, peer 1.1.1.1:0 up

    MPLS VC labels: local 20, remote unassigned

    Group ID: local 0, remote unknown

    MTU: local 1500, remote unknown

    Remote interface description:

  Sequencing: receive disabled, send disabled

  VC statistics:

    packet totals: receive 0, send 0

    byte totals:   receive 0, send 0

    packet drops:  receive 0, send 0

c7206#show logg

*Mar 19 21:18:25.303: AToM MGR [1.1.1.1, 666]: Remote end up

*Mar 19 21:18:25.303: AToM MGR [1.1.1.1, 666]: Validate vc, activating data plane

*Mar 19 21:18:25.303: AToM MGR [1.1.1.1, 666]: Remote end down, vc is down

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Processing imposition update, vc_handle 5297220, update_action 1, remote_vc_label 19

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Imposition Programmed, Output Interface: Gi0/1.100

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Processing disposition update, vc_handle 5297220, update_action 1, local_vc_label 20

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Processing imposition update, vc_handle 5297220, update_action 0, remote_vc_label 19

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Imposition Disabled

*Mar 19 21:18:25.303: AToM SMGR [1.1.1.1, 666]: Processing disposition update, vc_handle 5297220, update_action 0, local_vc_label 20

*Mar 19 21:18:25.303: AToM SMGR: Processing TFIB event for 1.1.1.1

*Mar 19 21:18:25.303: AToM SMGR: TFIB scan started

*Mar 19 21:18:25.303: AToM SMGR: TFIB scan complete

1 Accepted Solution

Accepted Solutions

Move fa1/0/1 to one of the ES ports as MPLS functionality is only supported on them.  Those are the SFP ports, g1/1/1, g1/1/2.  Also note that these ports will only work at gig speed, not fast ethernet. 

-Matt

View solution in original post

3 Replies 3

klausschneider
Level 1
Level 1

More detailed debug messages from 3750me:

00:17:50: AToM MGR [2.2.2.2, 666]: Local end down, vc is temporarily down

00:17:50: AToM MGR [2.2.2.2, 666]: Unprovision SSM segment

00:17:50: AToM MGR [2.2.2.2, 666]: Label 19 free for reuse in 202 sec

00:17:50: AToM MGR [2.2.2.2, 666]: Receive SSM dataplane up notification

00:17:50: AToM MGR [2.2.2.2, 666]: Label 19 released while on hold, reduce hold time to 20 sec

Move fa1/0/1 to one of the ES ports as MPLS functionality is only supported on them.  Those are the SFP ports, g1/1/1, g1/1/2.  Also note that these ports will only work at gig speed, not fast ethernet. 

-Matt

Thank you matthew