as I understand it, the 3850 has only one default queue for all traffic (which includes control traffic). So there is no default dscp to output queue mapping. To map DSCP values to a queue and actually create the queue, you need to define a class. The below will create two queues, one for the DSCP values you have specified, and one for the default class, which is all other traffic:
class-map DSCP_HIGH match dscp 32 48 54
policy-map DSCP_OUTPUT class DSCP_HIGH bandwidth percent 20 queue-buffers ratio 10 class class-default
there is a phrase "When no service-policy is applied, there are 2 default queues (queue 0 and queue 1). The queue-0 is used for control traffic (DSCP 32 or 48 or 56) and queue-1 is used for data traffic."
So at least 2 queues, thats why i wanted to see where other dscp will go. Or everything except 32,48,56 will go to second queue?
Hello We have 2 data centers with Direct Connects to AWS running BGP. The US DC advertises it's private /19 range and the CA DC advertises a /12, the problem is that the /19 falls within the range of the /12. Is there a way to prevent the CA DC from ...
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...