09-11-2019 11:14 AM
We have a Cisco 6509E chassis as the core of our network. We are trying to run our FOG (Imaging software) server and we are finding multicast is not working through the switch. We tested this by plugging the server into a variety of other switches that bypass the core and multicasting works perfectly. I am unsure what settings could be different as I have compared IGMP Snooping and the port-fast settings with the switches that work when the server is plugged into them.
Any ideas? It is running SUPT2XL as the supervisors running 15.1 on them.
Solved! Go to Solution.
09-11-2019 01:58 PM
Under the SVI interface for that vlan, try "ip PIM sparse-dense-mode"
HTH
09-11-2019 11:40 AM
If the core switch is layer-3, you may want to enabling PIM on the vlan interface (SVI) and than test again.
HTH
09-11-2019 12:57 PM
09-11-2019 01:22 PM
Usually when clients and server in the same vlan PIM is not needed but you may want to give it try anyway if all the other configs are applied correctly and you are not getting results.
HTH
09-11-2019 01:25 PM
09-11-2019 01:58 PM
Under the SVI interface for that vlan, try "ip PIM sparse-dense-mode"
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide