10-15-2021 12:16 AM
Can Anyone please tell me how to connect the two highlighted Devices?
Solved! Go to Solution.
10-15-2021 01:10 AM
Hello,
there were numerous misconfigurations:
1. Vlan 6 interface on the Engineering switch had a duplicate IP address (10.33.6.1), I changed that to 10.33.6.2
2. GigabitEthernet0/1 on the GQ router had a wrong subnet mask (24 instead of 30)
3. OSPF was misconfigured on all devices. For convenience, I added all networks to the OSPF processes.
You now have full end to end connectivity, review the file attached (saved in Packet Tracer version 8).
10-15-2021 12:32 AM
Hello,
which two devices do you need to connect, the HQ router and the Engineering L3 switch ?
Post the zipped Packet Tracer project (.pkt) file...
10-15-2021 12:34 AM
HQ Router and PCs connected to Engineering L3 Switches
10-15-2021 12:38 AM
Hello,
it is impossible to see what you have configured without you posting either the configurations of your devices or, better yet, the zipped project file.
10-15-2021 12:42 AM
10-15-2021 01:10 AM
Hello,
there were numerous misconfigurations:
1. Vlan 6 interface on the Engineering switch had a duplicate IP address (10.33.6.1), I changed that to 10.33.6.2
2. GigabitEthernet0/1 on the GQ router had a wrong subnet mask (24 instead of 30)
3. OSPF was misconfigured on all devices. For convenience, I added all networks to the OSPF processes.
You now have full end to end connectivity, review the file attached (saved in Packet Tracer version 8).
10-15-2021 01:15 AM
Thank You So Much Georg
10-15-2021 03:00 AM
Hello,
no worries, just a few small changes, the rest of the network looks very good ! Good luck with your studies !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide