I have a N5K-5672UP with enterprise license and I execute these commands to protect my control plane :
control-plane
service-policy input copp-system-policy-default
There is 2 issues:
When I execute show run copp it does not show anything and even when I check whole of the show run with my eyes there is no copp config.
when I send TCP syn attack towards my control plane my CPU usages is around %20-30 but my bgp session goes down and I can enter command slowly, whats wrong?
here is show copp status output: show copp status
Last Config Operation: service-policy input copp-system-policy-default
Last Config Operation Timestamp: 08:51:29 GMT Nov 21 2021
Last Config Operation Status: Success
Policy-map attached to the control-plane: copp-system-policy-default
Thank you.