N7K - defaulting an interface causes the module to reset

[pokwan]

Hi,

Has anyone experienced the problem where a default interface command causes the module to reset?

For instance

default int e1/10 - 11

The command above resets module 1.

We are using version 6.2(16).

TIA

PF

[Reza Sharifi]

Hi,

I have never seen that.  You may want to upgrade to a newer version (7.x) and test again.  If not you may have to RMA the module back to Cisco.

HTH

[pokwan]

Thanks Reza,  this is the error messages on the log

2017 Sep 14 10:51:08.546 TP-H7-CSW-01 %SYSMGR-SLOT1-2-SERVICE_CRASHED: Service "aclqos" (PID 2376) hasn't caught signal 11 (core will be saved).
2017 Sep 14 10:51:12.681 TP-H7-CSW-01 %SYSMGR-SLOT1-2-SERVICE_CRASHED: Service "aclqos" (PID 29925) hasn't caught signal 11 (core will be saved).
2017 Sep 14 10:51:16.904 TP-H7-CSW-01 %SYSMGR-SLOT1-2-SERVICE_CRASHED: Service "aclqos" (PID 29982) hasn't caught signal 11 (core will be saved).

Thanks.

PF