Re: N9K Port mirroring not working ?

axelhauguel · ‎10-24-2021

Hello,

I'm trying to enable SPAN over a 100G port for packet inspection but i can't get it to send traffic.

On the N9K everything seems to be working, but on the other side i doesn't get any traffic.

I enabled the SPAN with these commands :

monitor session 1
source interface Ethernet 1/53 both
destination interface Ethernet 1/52
no shut

Do anyone have an idea why it is not working ?

Am i doing something wrong or is it a limitation of the N9K ?

Yours thanksfully,

Axel

marce1000 · ‎10-24-2021

- Anything in the logs when you activate this mirroring-session ?

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

axelhauguel · ‎10-24-2021

Hello,

There is nothing in the logs, the last log entry is not even today.

balaji.bandi · ‎10-24-2021

what is the version of code, what is the model of the switch, can you post interface config

show version

show run interface eth1/53

show monitor session 1

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help