I have a cisco 1811 router connected to a customers network via a serial lan.
The Cisco 1811 is connected to my core via VPN.
The serial lan is setup at NAT outside and it's ip is 10.10.10.1/30.
The 1811 has a 172.30.1.0/24 network that is set as NAT inside
The customer is sending data to me from a server with ip address 192.168.100.100.
Is it possible to NAT the 192.168.100.100 address to a 172.30.1.xxx address?
I cannot change the NAT designations on the interfaces because I am already doing several inside source static nats to make servers on the 172.30.1.0 network appear on their net as 192.168.100.x devices.
Also, I already have a vpn setup with another customer who is using the 192.168.100.100 address, so I need to NAT this customers ip to something else, preferebly in the ip space that is already permitted in the vpn.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...