cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

3183
Views
0
Helpful
2
Replies
Highlighted

Native VLAN Mismatch

Hi,

I have configured the port channel for two ports in Cisco 3750 switch. While connecting the cable in that port i am getting the native VLAN mismatching error. Below i have attached the configuration and error details. Please help me on this.

Error:

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/17 (1).

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/17 (1).

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/17 (1).

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/34, changed state to up

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/34 (1).

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/34 (1).

%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet1/0/33 (5), with Core1 GigabitEthernet1/0/34 (1).

Configuration:

interface Port-channel3

description *****Connected to Dell Blade Server Switch****

switchport trunk encapsulation dot1q

switchport mode trunk

interface GigabitEthernet1/0/17

description *****Connected to Blade*****

switchport trunk encapsulation dot1q

switchport mode trunk

speed 1000

duplex full

channel-protocol lacp

channel-group 3 mode active

!

interface GigabitEthernet1/0/33

description *****Spare*****

switchport access vlan 5

!

interface GigabitEthernet1/0/34

description *****Connected to Blade*****

switchport trunk encapsulation dot1q

switchport mode trunk

speed 1000

duplex full

channel-protocol lacp

channel-group 3 mode active

!

Thanks,

Karthik

Everyone's tags (4)
2 REPLIES 2
Contributor

Re: Native VLAN Mismatch

en

conf t

int g1/0/33

sw mo acc

sw acc vlan 1

end

wr

!

Alessio

      

PS: eagle eye !! thanks Peter

Hall of Fame Cisco Employee

Native VLAN Mismatch

Hi Alessio,

sw acc nat vlan 1

You probably meant switchport access vlan 1 (i.e. remove the "nat" shorthand).

Your suggestion would surely remove the native VLAN mismatch issue. However, I also suggest verifying whether the Gi1/0/17 on Core1 is configured as an access port or if it is a trunk. If it is a trunk then clearly, the 3750 should also be configured as a trunk.

Best regards,

Peter

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards