Need to allow VLAN at specific link

[Mahmoud Marie]

Hello,

I have two PCs connected to the same switch and there are two uplinks to another switch as the below diagram, just need to know how to let VLAN 40 going through "Dark-Fiber-1" Port1 and VLAN30 going through "Dark-Fiber-2" Port-5

Appreciate you help

Thanks

[MHM Cisco World]

https://www.cisco.com/c/en/us/support/docs/lan-switching/spanning-tree-protocol/10555-15.html

MHM

[Mahmoud Marie]

They not a redundant links, its a separated links. Just need to allow VLANs at each link.

Link-1 for VLAN-40 traffic only and Link-2 for VLAN-30 only

Thanks

[MHM Cisco World]

If that so 

Config each port as access 

And assign vlan to port.

Note:- this work if you run pvst not rstp'

So what STP mode you run in SW?

MHM

[MHM Cisco World]

this lab for you

the port config with 

swithport access vlan 10/100 
and both SW run PVST or (rapid-PVST)

and it work the VLAN1 since it run by default in both link one side is BLK and other is FWD 
and for VLAN 10/100 the port is FWD