10-08-2018 10:57 AM - edited 03-08-2019 04:20 PM
Solved! Go to Solution.
10-08-2018 11:20 AM
Can you send the output of the following commands?:
- show version
- show ip ssh
- show run | s line
Thanks,
Cesar Fernandez J
10-08-2018 11:08 AM
You did provide much of explanation but that is maybe because you don't have a username and password set up.
HTH
10-08-2018 11:15 AM
10-08-2018 11:54 AM
What is the uptime of the switch ? Sometimes a reload helps with these issues...
10-08-2018 12:45 PM
Is the switch reachable?
Can you ping the IP?
10-08-2018 11:20 AM
Can you send the output of the following commands?:
- show version
- show ip ssh
- show run | s line
Thanks,
Cesar Fernandez J
10-10-2018 02:24 PM
02-04-2023 11:46 PM
greetings,
can tell me how can check if the SSH enable or not
thanks
02-05-2023 12:06 AM - edited 02-05-2023 12:06 AM
Use the command show ip ssh.
Example output:
Device# show ip ssh SSH Enabled - version 1.5 Authentication timeout: 120 secs; Authentication retries: 3
When SSH is disabled you get the following result:
Device# show ip ssh %SSH has not been enabled
Regards
Wassim
02-05-2023 08:04 PM
but i'm not able to access CLI how can run this command
02-05-2023 09:39 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide