cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2723
Views
0
Helpful
5
Replies

Nexus 3048 port-channel to 3750G issues.

conley851
Level 1
Level 1

I am trying to bring up a trunk between a 3750G stack and (2) Nexus 3048. The uplinks on the 3048's are using 1gig MM SFP. The ports on the 3750 stack are configured as a port channel. I have checked the SFPs, they are valid. I had swapped out fiber patch cables, SFPs. I have included the configurations below, so any help is appreciated!

Configuration on the 3750 stack:

!

interface GigabitEthernet4/0/7

description ***To C1R2NX3048-1***

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,255

switchport mode trunk

channel-group 11 mode active

end

!

interface GigabitEthernet5/0/7

description ***To C1R2NX3048-2***

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,255

switchport mode trunk

channel-group 11 mode active

end

!

interface Port-channel11

description *** To C1C2NX3048***

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,255

switchport mode trunk

end

Nexus #1 Configuration:

interface Ethernet1/49

  description TO-C1R2CS3750-1

  switchport mode trunk

  switchport trunk allowed vlan 1,255

  speed 1000

  channel-group 101 mode active

!

interface port-channel101

  description L2-TO-WLS1C1R1CS3750-2

  switchport mode trunk

  vpc 101

  switchport trunk allowed vlan 1,255

  spanning-tree port type normal

  speed 1000

port-channel101 is down (No operational members)

vPC Status: Down, vPC number: 101

  Hardware: Port-Channel, address: 0000.0000.0000 (bia 0000.0000.0000)

  Description: TO-C1R1CS3750-2

  MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is trunk

  auto-duplex, auto-speed

  Beacon is turned off

  Input flow-control is off, output flow-control is off

  Switchport monitor is off

  EtherType is 0x8100

  Members in this channel: Eth1/49

  Last clearing of "show interface" counters never

  30 seconds input rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  30 seconds output rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  Load-Interval #2: 5 minute (300 seconds)

    input rate 0 bps, 0 pps; output rate 0 bps, 0 pps

  RX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 input packets  0 bytes

Ethernet1/49 is down (Link not connected)

  Hardware: 1000/10000 Ethernet, address: c08c.603d.4f98 (bia c08c.603d.4f98)

  Description: TO-C1R2CS3750-1

  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is trunk

  auto-duplex, 1000 Mb/s, media type is 1G

  Beacon is turned off

  Input flow-control is off, output flow-control is off

  Rate mode is dedicated

  Switchport monitor is off

  EtherType is 0x8100

  Last link flapped never

  Last clearing of "show interface" counters 22:13:17

  30 seconds input rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  30 seconds output rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  Load-Interval #2: 5 minute (300 seconds)

    input rate 0 bps, 0 pps; output rate 0 bps, 0 pps

  RX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 input packets  0 bytes

Nexus #2 Configuration

interface Ethernet1/49

  description TO-C1R2CS3750-1

  switchport mode trunk

  switchport trunk allowed vlan 1,255

  speed 1000

  channel-group 101 mode active

interface port-channel101

  description TO-C1R1CS3750-2

  switchport mode trunk

  vpc 101

  switchport trunk allowed vlan 1,255

  speed 1000

Ethernet1/49 is down (Link not connected)

  Hardware: 1000/10000 Ethernet, address: c08c.603d.51d8 (bia c08c.603d.51d8)

  DescriptionTO C1R2CS3750-1

  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is trunk

  auto-duplex, 1000 Mb/s, media type is 1G

  Beacon is turned off

  Input flow-control is off, output flow-control is off

  Rate mode is dedicated

  Switchport monitor is off

  EtherType is 0x8100

  Last link flapped never

  Last clearing of "show interface" counters 02:31:20

  30 seconds input rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  30 seconds output rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  Load-Interval #2: 5 minute (300 seconds)

    input rate 0 bps, 0 pps; output rate 0 bps, 0 pps

  RX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 input packets  0 bytes

    0 jumbo packets  0 storm suppression packets

    0 giants  0 input error  0 short frame  0 overrun   0 underrun

    0 watchdog  0 if down drop

    0 input with dribble  0 input discard(includes ACL drops)

    0 Rx pause

  TX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 output packets  0 bytes

    0 jumbo packets

    0 output errors  0 collision  0 deferred  0 late collision

    0 lost carrier  0 no carrier  0 babble

    0 Tx pause

  0 interface resets

port-channel101 is down (No operational members)

vPC Status: Down, vPC number: 101

  Hardware: Port-Channel, address: 0000.0000.0000 (bia 0000.0000.0000)

  Description: TO-C1R1CS3750-2

  MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is trunk

  auto-duplex, auto-speed

  Beacon is turned off

  Input flow-control is off, output flow-control is off

  Switchport monitor is off

  EtherType is 0x8100

  Members in this channel: Eth1/49

  Last clearing of "show interface" counters never

  30 seconds input rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  30 seconds output rate 0 bits/sec, 0 bytes/sec, 0 packets/sec

  Load-Interval #2: 5 minute (300 seconds)

    input rate 0 bps, 0 pps; output rate 0 bps, 0 pps

  RX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 input packets  0 bytes

    0 jumbo packets  0 storm suppression packets

    0 giants  0 input error  0 short frame  0 overrun   0 underrun

    0 watchdog  0 if down drop

    0 input with dribble  0 input discard(includes ACL drops)

    0 Rx pause

  TX

    0 unicast packets  0 multicast packets  0 broadcast packets

    0 output packets  0 bytes

    0 jumbo packets

    0 output errors  0 collision  0 deferred  0 late collision

    0 lost carrier  0 no carrier  0 babble

    0 Tx pause

  0 interface resets

5 Replies 5

Wilson Bonilla
Level 3
Level 3

Hello Dan.

- What if you remove the configuration, are the interface coming up as individuals?

- What if you try to loop the fiber cables, for example plug the fiber from the interface 4/0/7 to the 5/0/7 in the same stack, is the interface coming up? try the same test in the 3k.

Can you put in a notepad the output of the following commands and attach it.

- Show log (both switches)

- Show interface status err-disable. (both switches)

- Show inventory (both switches)

- Show version.

Regards.

Wilson B.

Hi Wilson-

Thanks for the reply. To answer your questions:

- If i remove all of the configuration, they do NOT come up. All interfaces still show as not connected.

- I can loop the fiber cables and get lights. I looped the two nexus switches on eth1/49 on both switches successfully, and 4/0/7 to 5/0/7 successfully.

Attached is the output that you were looking for. Thanks again!

Hi Dan.

Thank you for the ouputs, I checked the show inventory, it doesn't populate the transceivers number, only the serial number, and when I search for the transceiver serial number it doesn't show up with any result. So are those cisco transceivers? ...

can you share the transceiver part number!

Regards.

Wilson B

Wilson-

I noticed that as well when I sent this to you. I am going to reboot that switch tonight, because there are all Cisco transceivers in it, and there are some other funny things going on.

I found the issue with this. On the 3750G ports, I had to set 'speed nonegotiate' on the trunks going to the 3k's.

Thank you for the help!

Dear Dan,

The Same Issue I am facing with my Nexus Switch and 3750 Core Switch, Can u Pls Guide me How to Fix this issue?

CDP Neighbour shows the device, but not pinging.

Thanks,

Tamizh

Review Cisco Networking for a $25 gift card