02-07-2012 10:29 AM - edited 03-07-2019 04:47 AM
All,
I have a pair of 5548P switches with the L3 daughter cards installed. Using the base license as I just need RIP routing. I have the two switches setup and have the RIP routing feature enabled. When I "turn on" routing using RIP I do not get any routes from my existing L3 switch (3750). I probably don't have routing setup correctly. With the 3750 IOS, I just turned on RIP with the router rip command and added a couple of network statements. On the nexus I have run router rip {instance} and left it at that. I am not getting any routes from my 3750. The 5548s are using the management ports and are connected to my existing network with L2 trunks. Does anyone know of a setup guide for RIP? I have used the Nexus 7000 RIP guide but still can't get it to work.
Thanks,
Ken
Solved! Go to Solution.
02-08-2012 10:14 AM
Greetings Ken,
You need to add the relevant interfaces (probably SVIs) to your RIP instance using the 'ip router rip
http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/unicast/5_0_3_N1_1/l3_rip.html
Cheers,
/Phil
02-08-2012 10:14 AM
Greetings Ken,
You need to add the relevant interfaces (probably SVIs) to your RIP instance using the 'ip router rip
http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/unicast/5_0_3_N1_1/l3_rip.html
Cheers,
/Phil
02-08-2012 10:33 AM
Thanks Phil,
That is what I needed. I didn't know that you needed to apply the instance to the interfaces. I appreciate the help and the link.
Ken
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide