07-11-2012 10:24 AM - edited 03-07-2019 07:43 AM
We recently replaced a 5596 due to an issue with SFP modules not being recognised on 1 port. We took the config off the old 5596 and put it onto the new one.
2 x 5596 nexus switches are connected together with one port being used a the peer keeaplive and then an 80gb port channel between the two switches. Not sure why it was designed this way but the issue I had was the following line was identified in the config in the new switch:
spanning-tree port type edge default
This caused major problems with vpc inconsistency and flapping.
In order to resolve the issue we removed this line and everything was working successfully.
My concerns are this command was not in the config taken off the switch thet was replaced. Is this command on by default on a Nexus 5596? How can this command appear other than explicitly executing it?
We did a direct copy and paste from the old switch to the new one so not sure why this command would appear in the configuration.
Any feedback would be very much appreciated.
Solved! Go to Solution.
07-11-2012 02:33 PM
Your right default is normal my mistake.
07-11-2012 02:45 PM
You could check the accounting log to see if the command was applied.
show accounting log
07-11-2012 02:19 PM
Do you have the following command configured:
spanning-tree port type edge bpdugaurd default
If so is it possible in the copy and paste the bpdugaurd did not paste in resulting in spanning-tree port type edge default?
The default port type should be network.
Is the code on the new 5K the same as the old one?
07-11-2012 02:27 PM
Thanks for the input Jim.
We do have spanning-tree port type edge bpduguard default in the command line.
Not sure if we could have copied and pasted this incorrectly.
I thought the default port type is Normal rather than network. You set it to network for bridge assurance. Am i right?
The code on the new 5k is the same as the old one as we downgraded it to the same level.
07-11-2012 02:45 PM
You could check the accounting log to see if the command was applied.
show accounting log
07-12-2012 02:42 AM
Thanks Jim. This shows me what I needed.
07-11-2012 02:33 PM
Your right default is normal my mistake.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide