Nexus 7710 with F3 1/10G not suport GLC-T

[patcbr600]

Hi all,

Hi have a nexus 7710 with F3 48x1/10G interfaces but i'm not able to configure a interface with GLC-T, the switch does not let to configure speed to 1000 and givs the following error:

Ethernet7/14
    transceiver is present
    type is 1000base-T
    name is CISCO-AVAGO     
    part number is ABCU-5710RZ-CS4
    revision is B2  
    serial number is AGM1714226D     
    nominal bitrate is 1300 MBit/sec
    Link length supported for copper is 100 m
    cisco id is --
    cisco extended id number is 4

Ethernet7/14
  Model:                 N77-F348XP-23
  Type (SFP capable):    1000base-T
  Speed:                 10000
  Duplex:                full
  Trunk encap. type:     802.1Q
  FabricPath capable:    yes
  Channel:               yes
  Broadcast suppression: percentage(0-100)
  Flowcontrol:           rx-(off/on),tx-(off/on)
  Rate mode:             dedicated
  Port mode:             Routed,Switched
  QOS scheduling:        rx-(8q4t),tx-(3p5q1t)
  CoS rewrite:           yes
  ToS rewrite:           yes
  SPAN:                  yes
  UDLD:                  yes
  MDIX:                  no
  TDR capable:           no
  Link Debounce:         yes
  Link Debounce Time:    yes
  FEX Fabric:            yes
  dot1Q-tunnel mode:     yes
  EFP:                   no
  Num Rewrites Allowed:  104
  Pvlan Trunk capable:   yes
  Port Group Members:    9-16
  EEE (efficient-eth):   no
  PFC capable:           yes
  Breakout capable:      no

 interface ethernet 7/14
 speed 1000
ERROR: Ethernet7/14: Configuration does not match the port capability.

Can anyone give a help on this, in the cco the GLC-T is supported.

Thanks

Patcbr600

[Steve Fuller]

Hi,

According to the Limitations section of the NX-OS 6.2 release notes, this is not supported:

N77-F348XP-23: 1 Gigabit Ethernet Not Supported
On the Cisco Nexus 7700 48-port 1/10-Gigabit Ethernet SFP+ I/O module (N77-F348XP-23), 1 Gigabit Ethernet port speed is not supported on the F3 Series modules in Cisco Nexus Release 6.2(6).

I don't think the wording is very clear, but the way I read this is that it's a software limitation that will change in later releases. Especially as it would be a pretty useless 1/10 GE module if it didn't support 1GE.

Regards

[haihuang]

1G is supported with software release 6.2.8:

http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#76711

[sean_evershed]

Try removing the SFP, set the speed and then re-insert it.

[cdtomkins]

Hi,

Did you ever resolve this? I will have this deployment scenario in a few months' time.

Thanks