Switching

Hello, I came across an issue with and cisco 1841 fa0/1 plug into a 8 port cisco switch  (G0/1) there are 3 sub ifs on the router 102030 I keep getting mac flap between GIG0/1 the uplink to the router and f0/1 which is in access mode and faces the cu...

Hi Team,Can we enable per packet load balancing/sharing in cisco 3560 and 4948 Switches ? I can see two routes are installed in routing table for a destination prefix but for traffic to specific destination is not going across both the link. The opti...

Hello, I need for a machine to be able to receive broadcasts on the VLAN it is attached to but not transmit to the VLAN.The machine is attached to a Catalyst 4948-E with enterprise feature set and also tried base feature set. I have tried to follow m...

Hi, I am checking if my ASA support for the SHAv2. But I couldn't find any option to choose for SHAv2 for the encryption algorithm.Anyone could suggest how to check if ASA can support SHAv2 and how to enable it? ASA version is 8.4(7)22   Thanks

After configuring "auto qos voip cisco-phone" on a stack of 2960x switches, we later noticed that after a power cycle (config was saved first) it went missing when doing a "show run" from the interface configs, on one of the switches (g1/0/1-48 had i...

Hello,I have a brand new switch that I can't seem to get up and running for days now.I have configured 2 ports of a 3650 . One port is on the outside 1/0/4 and one port is the inside of my network 1/0/5.Port 1/0/5 is a trunk port with only vlan 60 fo...

Hi guys, my current stack consists of 2x WS-C3750E-24TD and 1x WS-C3750G-12S.I would like to add 12 Ports of 10GB SFP+ SR somehow.Is there a 10GB SFP+ SR fiber distribution switch that is compatiblewith my stack?Many thanks!

I have Vlan 198, that works for some users and not for others. This Vlan on a 2811 Router, connected to a 6509 (Router 1) via port Gi8/1. I feel part of the issue in that Router 1 should be the root and not Router 2. I have tried to making router 1 t...

Hi all.  I am unsure of how to use the IOS CLI to configure a guest Wi-Fi netweork where it co-exists with an existing internal-only company Wi-Fi on the same router.  I have the internal Wi-Fi set up, but ideally would like to have a guest Wi-Fi acc...

Hi, I have a connectivity issue with vlan231 set on my smb SF302.  Here is my scenario my core is a 3750 interconnecting to this smb switch which i am able to remote in, but when set port to use vlan231 on the smb no traffic is passed to my pc set wi...

Hi Am getting frequent disconnection in few ports i have checked diag result everything perfect but in logging am getting the below error is this cause port disconnection and let me know how to solve this error. %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module...