Nexus 9K

[ShKhan]

Hello Experts,

I am using NX9K version 9.3(3), and I want to enable IGMP querier for L2 multicast, but I can't find the command, 

please see the attached picture and kindly advise!

Regards

[Reza Sharifi]

hi,

Have a look at the config guide on how to configure it.

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/multicast/configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS_Multicast_Routing_Configuration_Guide_7x/b_Cisco_Nexus_9000_Series_NX-OS_Multicast_Routing_Configuration_Guide_7x...

HTH

[ShKhan]

Hi,

I know the guide , but I can’t see the command under the vlan configuration , as mentioned in the attached picture.

[Jon Marshall · Accepted solution]

According to the guide you are not configuring it correctly. 

You are in interface mode but you should be in vlan configuration mode ie. 

switch(config)# vlan configuration <vlan ID>
switch(config-vlan-config)# ip igmp snooping
switch(config-vlan-config)# ip igmp querier <IP address>

Jon

[Reza Sharifi · Accepted solution]

Under vlan configuration:

(config-vlan-config)# ip igmp snooping querier 

[ShKhan]

finally there, thank you very much, everyone .