10-26-2006 02:15 PM - edited 03-05-2019 12:28 PM
I have been looking up Documentation on the NM-ESW-16 module and the Doc's I've read indicated that it is compatible with the 2811 router but when I drill down and try to find specific examples of how to use this module, all I keep running into is doc's on this module being compatible with the 2600 and 3600 routers.
Does anyone know where I could find documentation on compatibility for this module or sample config?
My problem is, I have a 2811 router with a NME-16ES-1G-P that I'm able to create sub-interfaces (for vlans) off the Gig interfaces that connects to the backplane of the router (gig1/0) but with my 2811 with the NM-ESW-16 I can't create subinterfaces even though I question mark "?" my way through and it says I can. Code I'm using is
c2800nm-advipservicesk9-mz.124-5a.bin
I've attached an example.
Any help would be greatly appreciated!
10-26-2006 03:19 PM
With the switch modules you have to create layer 3 SVI's like you would on any IOS layer switch like the 4506. Then apply the switchports vlans like you normally would.
Example
vlan database
vlan 2
name 192.168.2.0/24
Int vlan 2
ip address 192.168.2.254 255.255.255.0
Int g1/0
switchport access vlan 2
10-27-2006 05:12 AM
thank you! I will give it a try
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide