No Default Vlan 1 showing on 2811 Router

[pbiggs]

Hello,

I am sure this is a rookie mistake but your assistance would be greatly appreciated. I am an admin working on Cisco Routers and Switches. Throughout our network I am noticing Telnet not SSH is enabled. I want to enable SSH and I connected to one of our Cisco 2811 Routers and noticed it had no default vlan 1. When I attempt to add it going through the normal steps the router will not allow me to indicating the commands are not recognized? Has anyone seen this before?

Thank you in advance!

Pete

[Reza Sharifi · Accepted solution]

So, below is the IOS that is installed on this router and as you can see there is no "k9" in the image name.

c2800nm-ipbase-mz.151-1.T.bin

So, if your other router has a similar IOS with K9 in it, you can copy that IOS to this router's flash, change the boot variable to point to the new IOS, save the config, and reboot.

HTH

[pbiggs]

Reza!

Thank you!! I will do this.