03-27-2012 09:43 AM - edited 03-07-2019 05:48 AM
Hi
I have a Cisco 881 router with c880data-universalk9-mz.150-1.M7 IOS.
I can not issue the ip vrf command.
From which version of IOS this command is available?
Thanks
03-27-2012 10:48 AM
Accrding to my pass at feature navigator, its not available for that platform. I searched on mpls vpn cli for IPv4 /IPv6.
03-27-2012 11:17 AM
Hi
I search on Multi-VRF Support (VRF-Lite).
881 plataform with c880data-universalk9-mz.150-1.M7 IOS supports this feature.
03-27-2012 11:23 AM
When I issue ip ? command I get
Global IP configuration subcommands:
access-list Named access-list
accounting-list Select hosts for which IP accounting information is
kept
accounting-threshold Sets the maximum number of accounting entries
accounting-transits Sets the maximum number of transit entries
address-pool Specify default IP address pooling mechanism
admission Network Admission Control (NAC)
alias Alias an IP address to a TCP port
arp IP ARP global configuration
auth-proxy Authentication Proxy
bootp Config BOOTP services
cef Cisco Express Forwarding
classless Follow classless routing forwarding rules
ddns Configure dynamic DNS
default-gateway Specify default gateway (if not routing IP)
default-network Flags networks as candidates for default routes
device Device tracking
dhcp Configure DHCP server and relay parameters
dhcp-client Configure parameters for DHCP client operation
dhcp-server Specify target DHCP server parameters
dns Configure DNS server for a zone
domain IP DNS Resolver
domain-list Domain name to complete unqualified host names.
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
finger finger server
flow-aggregation Configure flow aggregation
flow-cache Configure netflow cache parameters
flow-capture Capture additional netflow information
flow-egress Configure netflow egress
flow-export Specify host/port to send flow statistics
flow-top-talkers Configure netflow top talkers
forward-protocol Controls forwarding of physical and directed IP
broadcasts
ftp FTP configuration commands
gratuitous-arps Generate gratuitous ARPs for PPP/SLIP peer addresses
host Add an entry to the ip hostname table
host-list Configure a host list
host-routing Enable host-based routing (proxy ARP and redirect)
hostname Configure hostname types
hp-host Enable the HP proxy probe service
http HTTP server configuration
icmp ICMP options
inspect Context-based Access Control Engine
local Specify local options
mfib Multicast Forwarding
mroute Configure static multicast routes
msdp MSDP global commands
multicast Global IP Multicast Commands
multicast-routing Enable IP multicast forwarding
name-server Specify address of name server to use
nat NAT configuration commands
nbar NBAR - Network Based Application Recognition
options IP Options treatment
port-map Port to application mapping (PAM) configuration
commands
prefix-list Build a prefix list
radius RADIUS configuration commands
rcmd Rcmd commands
reflexive-list Reflexive access list
route Establish static routes
routing Enable IP routing
sap Global IP Multicast SAP Commands
scp Scp commands
sctp Global SCTP parameters
security Specify system wide security information
sla IP Service Level Agreement
source-route Process packets with source routing header options
ssh Configure ssh options
subnet-zero Allow 'subnet zero' subnets
tacacs TACACS configuration commands
tcp Global TCP parameters
telnet Specify telnet options
tftp tftp configuration commands
traffic-export IP traffic export configuration commands
verify URPF SNMP trap and IP packet header validation command
03-29-2012 01:29 AM
Hello
880 series supports a single universal image with Cisco Software Activation. The active feature set is determined by the software
license installed on the platform.In this case, VRF Lite is only supported when the Adv. IP feature license is installed.Router#show license
Index 1 Feature: advipservices
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Regards
Sush
03-29-2012 07:51 AM
Hi
I will verifiy the active licenses
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide