Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello guys,I am about to redesign the core section of our data center, with all that stuff like Redundancy , Routing (mostly static ), Etherchanneling, Qtags etc. etc..  In other words all the things needed to get the whole Network efficient in throu...

rayborg by Level 1
  • 14892 Views
  • 6 replies
  • 0 Helpful votes

..I am connecting a Nexus 5K to a 6509 without VSS. Is the recommended configuration just straight etherchannel? Since the 6509 cannot do vpc, is an etherchannel the best way to configure this uplink? How does spanning-tree operate in this scenario?...

awatson20 by Level 4
  • 1307 Views
  • 3 replies
  • 0 Helpful votes

Dose anyone know major difrrence between Netflow v/s Netflow-Lite? I am trying to understand if Cisco 4948E can do the same job as Cisco 4500E or not and difrrence between Netflow v/s Netflow-Lite will help me select correct product. ThanksRitesh

rthakker by Level 1
  • 11233 Views
  • 2 replies
  • 0 Helpful votes

I have two 5548's in sync mode: I have an existing ACL and I want to add a new line to it, but after I do and try to commit it states the verify failed. What's there now:ip access-list SNMP-RO-ACL  10 permit ip 10.110.1.191/32 any  20 permit ip 10.11...

Hi every body, I am sya I have an idea for a database project linking several institutions located on an area of 19,000 square km and I would like to hear your advice---Posted by WebUser Sya Ahmed

Hello,I'm stock and I am sure it is simple but I can't find it.I have an ASA5510 from which I am using 3 interfaces.-One interface have the main internet connection router-One interface is attache to a switch 3750 and has multiple virtual interface c...

billetj09 by Level 1
  • 3230 Views
  • 10 replies
  • 0 Helpful votes

We have, for nearly 4 years, used EIGRP on our 6513 to  make use of two unequal links to our branch offices.  This worked because we could use the variance command and cause EIGRP to insert two routes into the table, one from each carrier.  Thus it w...

suelange by Level 1
  • 1782 Views
  • 5 replies
  • 0 Helpful votes

Hi All, I acquired a 3560X-24P-L Switch which I wanted to use at our datacenter.  However, I need a switch that supports OSPF.  It came with a Universal IOS but there was no "Router" command under conf t.  I downloaded and applied the latest "IP Base...

dkraut by Level 1
  • 2703 Views
  • 5 replies
  • 0 Helpful votes