05-21-2015 06:58 AM - edited 03-08-2019 12:06 AM
I saw this command amongst some OSPF config commands.
What does it do?
no passive-interface Vlan2
Solved! Go to Solution.
05-21-2015 07:19 AM
Most likely there is default passive interface for all the other interfaces in the same area of OSPF configs. So,"no passive-interface vlan2" means that the OSPF peering is over vlan 2 with the neighboring router.
more info:
In Open Shortest Path First (OSPF), hello packets are not sent on an interface that is specified as passive. Hence, the device is not able to discover any neighbors, and none of the OSPF neighbors are able to see the device on that network. In effect, this interface appears as a stub network to the OSPF domain. This configuration is useful if you want to import routes associated with a connected network into the OSPF domain without any OSPF activity on that interface.
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_pi/configuration/xe-3s/iri-xe-3s-book/iri-default-passive-interface.html#GUID-AE734874-728B-48D8-AC8D-14C74910DB5A
HTH
05-21-2015 07:19 AM
Most likely there is default passive interface for all the other interfaces in the same area of OSPF configs. So,"no passive-interface vlan2" means that the OSPF peering is over vlan 2 with the neighboring router.
more info:
In Open Shortest Path First (OSPF), hello packets are not sent on an interface that is specified as passive. Hence, the device is not able to discover any neighbors, and none of the OSPF neighbors are able to see the device on that network. In effect, this interface appears as a stub network to the OSPF domain. This configuration is useful if you want to import routes associated with a connected network into the OSPF domain without any OSPF activity on that interface.
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_pi/configuration/xe-3s/iri-xe-3s-book/iri-default-passive-interface.html#GUID-AE734874-728B-48D8-AC8D-14C74910DB5A
HTH
08-27-2018 07:03 AM
I would like to add the "no passive-interface" command to a device at a remote site in production during a "patch/upgrade" night. Usual patches are done remotely, but I am in fear of loosing connectivity to the device. Would it be safe to enter this command remotely or should i commit it onsite?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide