No Ping ...!!!!!! from Switch

[Mohammad Babjani]

Hi All,

I have an issue with one of my switch ( 4500 series) .

Actual Scenario: 

--------------------

We have a server which has two interfaces and each assigned with an IP address ( in the range[10.49.8.132/27]) . Eth0 IP:10.49.8.135 and Eth1 IP:10.49.8.136 .  Eth0 is connected to Switch-A and Eth-1 is connected to Switch-B . When tried to ping Eth0 IP it is success from switch-A whereas Eth-1 is not a success. Now the same IP's are pingable from the other switch-B . I am not sure what might be wrong . Please advise .

Thanks,

Babjani.

[chintalamuniraju]

Hi,

Can you please share your configurations. are you using any vlans in this switches

or default you are using ?

thanks

CRaju 

[Mohammad Babjani]

Hi Raju ,

Yes , we have vlans on both the switches . Here are the config files attached.

Thanks,

Babjani

[chintalamuniraju]

Hi

I checked the config.. files looks good .

 could you please give a try .

default gateway for your system to use Switch virtual interface  NOT HSRP Virtual ip address

I hope you understand my question . .

this is my mobile number 91+9618613678

Thanks

CRaju

[chintalamuniraju]

HI

As I discussed.

If it is possible to try to upgrade your IOS Version to latest .

because both version are different .

cat4500-ipbasek9-mz.150-2.SG5.bin

cat4000-i9k91s-mz.122-25.EWA5.bin

1.https://software.cisco.com/download/release.html?mdfid=279320804&softwareid=280805680&release=12.2.25-EWA&rellifecycle=ED&relind=DEFERRED&reltype=deferred/

2.https://software.cisco.com/download/release.html?mdfid=279636820&softwareid=280805680&release=15.0.2-SG5

Thanks

CRaju

[Mohammad Babjani]

Thank you Raju , will give it a try .

[Julio E. Moisa]

Hi

Your config looks fine, from what external source are you trying to ping it? is the 2nd NIC on the server configured with a gateway?

If they are on the same subnet they will be able to ping each other without gateway configured on the NICs. 

[Mohammad Babjani]

Hi Julio ,

Yes they are on the same subnet . Eth0 IP:10.49.8.135/27 and Eth1 IP:10.49.8.136/27 as mentioned earlier in the discussion . 

Thanks,

Babjani

[Julio E. Moisa]

Thank you, But Im referring if both NICs are configured with the gateway: 

10.49.8.134

[Mohammad Babjani]

Hi Julio,

Yes ,both the servers are using the standby IP of HSRP as their gateway. I am pinging it from the switches only and not from any other source .

[paul driver]

Hello

These switches seemed to be separate and not stacked or visualized

In a virtual stack link aggregation can span two switches as the server will see it a just one switch, However if the switch isnt "stacked" then the server connections need to be on the same switch in a link aggregation setup.(LACP) which I also don't see in you configuration.

I cannot comment on your server and its teaming software but having a server connected to two separate switches sharing the same address range and default-gateway and without any aggregation setup isnt really feasible.

res
Paul