I'm having an issue on 3 of my 4507 switches where there are 12 switches that we have that all are connected to my 7K Core switch all switches are on Transparent Mode and they all have the same VLAN but from one of the switches that I'm having an issue if I have a pc connected to VLAN 204 on the switch that is having issues I'm not able to ping the pc but is getting a DHCP address but if I move the pc to another switch that is not having the issue I'm able to ping the pc, but on the switch that I'm having the issue if I have the pc on VLAN 204 I'm not able to ping all my switches but if I put the pc on a different VLAN on the same switch that I'm having the issue I'm able to ping all my switches any thoughts on this need help thank you.
Can you share the "show version" output?
Also can you add the command "ip routing" on the switch ( configuration mode )where the inter vlan routing happening and try the test again?
If it still not worked, Share the below output:
"Show ip route"
From the switch ping <vlan 204 ip> source vlan 14 check if that works. In case if that does not work then that is the problem we are having currently.
Also share the "show run int vlan 204" * show run int vlan 14" on the switch.
With respect your output i do see the static route configured and also in the show version the license is Lan base.
Lan base does not work with static routing or other routing protocol.
Was the device running in Lan base before?
Also the working device are also in Lan base? Can you confirm on this?
If not, then upgrade the license to IP or higher to resolve the issue.
Also you were saying about vlan 17 and 204. However here it shows vlan 10. Exact topology diagram with the network address and vlan ID would help to narrow the issue and also from where we are ping to which device with working and not working "show ip route" & "show version"output.