08-05-2020 05:34 AM
Hi all,
we are not seeing VSS second switch in sh run. is that normal ?
only one switch from virtual domain:
switch virtual domain 10
switch mode virtual
switch 1 priority 255
mac-address use-virtual
but on sh sw virtual - we see both switches
- is that ok or we hit some bug ?
Solved! Go to Solution.
08-07-2020 02:58 AM
Hi,
It seems normal (for me also the same), But make sure that Show switch and virtual stack must show both switch's health.
Also, Both switches interface must show and accept the commands (I know DAD and SVL ports will not accept any other commands :) ).
08-05-2020 06:32 AM
Hi,
we are not seeing VSS second switch in sh run. is that normal ?
That is not normal. "sh run" should show all interfaces for both switch-1 and 2, if not you will not know what to configure on the second switch's interfaces starting with 2/1/x.
HTH
08-07-2020 12:34 AM
l posted the output above - is that the space from sh tech where the second switch shall be seen ?
could you please send me output from your switch so that l can check if l am looking into the right part of log ?
thanks
08-07-2020 02:20 AM
Hey,
could you post the outputs of the following commands?
#show version
#show redundancy states
#show switch virtual
Thanks and br
Juls
08-07-2020 02:58 AM
Hi,
It seems normal (for me also the same), But make sure that Show switch and virtual stack must show both switch's health.
Also, Both switches interface must show and accept the commands (I know DAD and SVL ports will not accept any other commands :) ).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide