I am going to be implementing a local NTP server onsite.
My question is if I point my Cisco router to receive the sync from my 3rd party NTP server, can I then point switches/other network devices connected off my Cisco router to receive the sync from the Cisco router itself rather than the NTP server itself? If so what commands are required.
You could just point the other devices to the Cisco router ip address , rather than the NTP server IP , pick a logical ip that's always up on the Cisco router to point too , loopback etc
You could just point the other devices to the Cisco router ip address , rather than the NTP server IP , pick a logical ip that's always up on the Cisco router to point too , loopback etc
ntp server x.x.x.x (Cisco router ip) prefer
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
