03-21-2017 04:53 AM - edited 03-08-2019 09:50 AM
Hi All
I am going to be implementing a local NTP server onsite.
My question is if I point my Cisco router to receive the sync from my 3rd party NTP server, can I then point switches/other network devices connected off my Cisco router to receive the sync from the Cisco router itself rather than the NTP server itself? If so what commands are required.
Regards
James
Solved! Go to Solution.
03-21-2017 05:23 AM
You could just point the other devices to the Cisco router ip address , rather than the NTP server IP , pick a logical ip that's always up on the Cisco router to point too , loopback etc
ntp server x.x.x.x (Cisco router ip) prefer
03-21-2017 05:23 AM
You could just point the other devices to the Cisco router ip address , rather than the NTP server IP , pick a logical ip that's always up on the Cisco router to point too , loopback etc
ntp server x.x.x.x (Cisco router ip) prefer
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide