NTP Synchronize problem

[goutam_04]

Hi,

I have configured NTP server properly and it was working fine.  But due to some reason I had to configure "Ip routing" on switch.  After that I have been facing this problem. i.e. NTP is not synchronized.

Again when I remove "Ip routing" command then its working fine.  Could any one can give me some idea why its happening.

Thanks

Goutam

[glen.grant]

So did you check to see if you are using a default gateway command or a default static route?  Have no idea why they would tell you changing it from a layer 2 switch to a layer 3 functional switch , that should make no difference of why it crashed , we have hundreds of 3560's setup as L2 only..  I would post your config on the switch you are talking about.