cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
29205
Views
9
Helpful
3
Replies

OID for Show Mac Address-Table

NiclasAnd
Level 1
Level 1

We got a 3750x Switch running IOS 12.2(53), and we want to get "show Mac Address-table interface gi 1/0/19" information out of the switch and into a SNMP tool. But we can't find any information about the OID that match "show Mac Address-table".

Anyone have an OID number I can look for, with MIB Walk?

3 Replies 3

Fabrizio Pedracini
Cisco Employee
Cisco Employee

Hi Niclas,

depends on the platform/IOS, but normally you should be able to get the mac address table using object dot1dTpFdbEntry, OID 1.3.6.1.2.1.17.4.3.1 from the BRIDGE-MIB group.

from  the MIB locator page:

dot1dTpFdbEntry

"Information about a specific unicast MAC address for which the bridge has some forwarding and/or filtering information."

check this page for more info:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a9b.shtml

hope this helps,

Fabrizio

Thank you for the answer, I will look into it.

/Niclas

No it doesn't, OID object dot1qTpFdbEntry is not supported by Cisco, instead dot1dTpFdbEntry is supported as you said, but this doesn't solve the issue because dot1d object only catches addresses on vlan 1 - 1001 and not the extended vlans

So anyone out there can help with this question??

Review Cisco Networking for a $25 gift card