Good day, I have a cisco C1000 switch, and it is showing output errors. There are no other errors on the interface. this is happening on several interfaces. I was thinking the buffers were overflowing but there are no errors on output buffer failures.
Also QOS is not enabled on this switch
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:10, output 00:00:00, output hang never
Last clearing of "show interface" counters 4d16h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 120137
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 54000 bits/sec, 14 packets/sec
5 minute output rate 35000 bits/sec, 26 packets/sec
98079045 packets input, 3905032892 bytes, 0 no buffer
Received 23915 broadcasts (13530 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 13530 multicast, 0 pause input
0 input packets with dribble condition detected
59530207 packets output, 1300128913 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Any help would be greatly appreciated.
