Packet Tracer - Cant Edit Interface on Router

[seansmith08964998]

Hi, I'm new to PT and trying to follow a tutorial on how to assign an IP to a router interface. For some reason, when i try to enter the port number to try and do this, i'm just thrown back into enable mode rather than conf-if mode. Is there something I'm doing wrong here. Below shows my process.

Router>enable

Router#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#interface gigabitEthernet 0/0/0

Router#

%SYS-5-CONFIG_I: Configured from console by console

Any help is much appreciated!

Sean

[luis_cordova]

Hi @seansmith08964998 

Maybe it is a PT bug.
What router are you using?
With this info I will check on my PC.

Regards

[seansmith08964998]

It's an extremely basic setup. Its just a 4321 Router connected to a 3650 Multilayer switch. I've attached a screenshot to illustrate the setup.

I thought it may also be a bug. I've tried re-starting PT and using different routers and switches, however I still have the same issue.

Thanks for your help

[Georg Pauwen]

Hello,

it works in version 7.3.0. Try and 'no shut' the interface first, before assigning the IP address...

[seansmith08964998]

Thats the issue though, If i try to access the interface to execute a no shutdown command or assign an ip, I am kicked out to enable mode. I've attached a screenshot of the issue

Thanks for your help

[luis_cordova]

Hi @seansmith08964998 

It must be a PT bug.
I suggest you uninstall the program and reinstall it.
I have recreated the topology and it works for me.

Regards