09-23-2024 05:04 AM
Hi! I'm experiencing an issue where all PCs in VLANs 10 and 20 receive the correct IP addresses via DHCP. However, the client (PC4), connected to the same VLAN and switch as the DHCP server, is not getting the correct IP configuration. This problem occurs whenever I add a new PC to the same VLAN as the DHCP server. Interestingly, if I relocate the DHCP server to a different VLAN, such as VLAN 40, and reconfigure the router accordingly, PC4 receives the correct IP configuration.
Sincerely,
Dennis
Solved! Go to Solution.
09-23-2024 06:08 AM
Could you share the configuration of SW that PC4 and DHCP server are connected?
09-23-2024 06:08 AM
Could you share the configuration of SW that PC4 and DHCP server are connected?
09-25-2024 07:38 AM
Hi! The issue was that inside my DHCP-services tab I had four different pools, one for each VLAN which were named VLAN10 etc. and the default pool that is called "serverPool" which cannot be removed. I was not aware that I had to use the default pool called "serverPool" on the DHCP-server to assign IP-adresses to the computers in VLAN "30" so when I removed the pool that I named VLAN30 and just used the pool called "serverPool" as the pool for VLAN "30" the assigned IP-addresses were correct.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide