07-01-2020 11:20 AM - edited 07-01-2020 11:32 AM
This is my first post here so hello world!
Trying to setup perpetual PoE on C2960XR-24PD-I (White pages says its supported) but the command doesn't seem to be present in the iOS build that I have installed on it. CCP 1.8 shows the option to enable perpetual PoE but setting it up in CCP fails due to the command not being there in iOS
Switch: C2960XR-24PD-I
Firmware: 15.2(7)E2 C2960X-UNIVERSALK9-M
Is there an image I can install that supports perpetual PoE on this switch?
do I need to enable that feature somehow?
am I wrong to assume that this switch supports perpetual PoE?
Does it require secondary Power Supply to it to work? (I only have one power supply in there)
switch(config-if)#power inline port perpetpual-poe-ha ^ % Invalid input detected at '^' marker.
07-03-2020 01:29 AM
see this IOS 15 document
table Supported Hardware for Perpetual POE, Fast POE and 2-event reports only 3850 models no 2960
07-03-2020 02:20 AM - edited 07-03-2020 02:38 AM
this document says it is available for the C2960XR platform
Cisco Catalyst 2960-X and 2960-XR Series Switches feature:
PoE+ support with a power budget of up to 740W and Perpetual PoE
us the inline help: "switch(config-if)#power inline port ? "
to check if either perpetual of poe-ha individually is available on this switch
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide