Switching

Hi Folks, Please let me know how to disable TLS/SSLv3 in 6500 cisco switch and to verify the status of the TLS/SSLv3. Thanks in Advance !!!

Hi, I was entering the command show redundancy on a 6K switch to verify the boot variable on the switch and when reading the output it shows something like this: BOOT= bootdisk:filename.bin, 12; I was wondering, what does that "12" means? Thank you!

Hello and sorry for my english I have to reload 3 switch who are stacked. My first question is : how to reload all the swich in stack in one command ? and how reload one by one ?show switch detailSwitch/Stack Mac Address : 00da.551f.2f80 - Local Mac ...

Hello Experts,  We have multiple 2960 switches connected to a backbone switch in star topology. Ofcourse, i got the Trunk interface - but is there a separate way where I dont need to specify multiple trunk ports on backbone switch for each individual...

I am in the planning phase of my network design project where I need to implement a Routed Access Campus design. We have a collapsed core and L3 switches as access layer. I understand that all switches will be configured point to point between access...

I am trying to recover the password of Catalyst 2960-s PoE ( WS-C2960S-24PS-L 12.2(55)SE3 C2960S-UNIVERSALK9-M) but no options are working like by pressing Mode button and by giving the under mentioned commands switch: flash_initswitch: load_helpersw...

We have 2 unit Cisco 9200L with POE (Cisco IOS XE Gibraltar), When we configure trunking port on Gi1/0/24 for both switch, then connect with UTP cable, the port is not functioned. The command for each port:Switchport mode trunkSwitchport trunk allowe...

Hi All,   Can anyone have to work RMON with PRTG SMTP_Sensor from Cisco Catalyst Switches such as 3850/2960? Any reference or working config for the same?   Basically I wanna monitor for interface traffic and error (CRC, Output error, etc).   Keep in...

Hi,  Currently, our 6500 switch logs unreachable ip addresses as "denies" in it's Syslog messages.And to be more specific, it will allow traffic to a host, but if that host goes offline and can't reach it, the packet is denied under the acl that norm...

I recently unboxed and partially configured two C9500-48Y4C's, which I upgraded to Gibraltar 16.12.03a. I am unable to find the right documentation on correctly configuring SSH to work properly, after using configurations that have worked on other mo...