ping problem

[bkoum]

hello

there are two 3550 connected using the fa 0/1 port and althought i can ping one another throught interface vlan1 , i cant ping to the interface fa0/1 from the vlan1 using extended ping. also i cant see any routing update in the routing table.

can anybody help ?

thanks

[Edison Ortiz]

Can you modify your RIP environment with Version 2 and disable auto-summary ?

For instance:

router rip

version 2

network 100.0.0.0

network 192.168.12.0

network 192.168.30.0

network 195.167.73.0

no auto-summary

on both routers

[bkoum]

hello

i tested it but still nothing

Mpoumpoulinas42#ping

Protocol [ip]:

Target IP address: 192.168.12.25

Repeat count [5]:

Datagram size [100]:

Timeout in seconds [2]:

Extended commands [n]: y

Source address or interface: 100.100.100.1

Type of service [0]:

Set DF bit in IP header? [no]:

Validate reply data? [no]:

Data pattern [0xABCD]:

Loose, Strict, Record, Timestamp, Verbose[none]:

Sweep range of sizes [n]:

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.12.25, timeout is 2 seconds:

.....

Success rate is 0 percent (0/

i was thinking it would be easy to connect two 3550 with routing but i can understand why its so complecate.

[hardiklodhia]

hello,

as per ur config,ip address 192.168.12.25 belongs to wht? host connected fa0/3 of Mpoumpoulinas42? or anything else??

if host then whts configured dg?

first try normal ping whether it is pinging.

let us know the results.

rgrds,

[bkoum]

yes , host 192.168.12.25 belongs into a switch connected at fa0/3 ....normal ping respond 5/5.

[hardiklodhia · Accepted solution]

can u ping 100.100.100.1 from that host? whts default gateway configured on ur host?it should be 192.168.12.5

[bkoum]

It should be but it is nt :) this maching connected to the internet via another adsl router ...thanks