03-31-2014 02:10 AM - edited 03-07-2019 06:55 PM
Hi ,
ive setup a pptp server on router , but i want to make sure that multicast udp packets are exchanging between my local lan and users that come by pptp tunel
here is my config of router :
=========================
cisco900#sh run
no ipv6 cef
ip source-route
ip cef
!
!
!
ip multicast-routing
!
!
!
multilink bundle-name authenticated
!
vpdn enable
!
vpdn-group 1
! Default PPTP VPDN group
accept-dialin
protocol pptp
virtual-template 1
l2tp tunnel timeout no-session 15
!
vpdn-group 2
! Default L2TP VPDN group
accept-dialin
protocol l2tp
!
!
!
!
interface GigabitEthernet0/0
ip address x.x.x.x 255.255.255.0
ip pim dense-mode
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 10.20.30.1 255.255.255.0
ip pim dense-mode
ip nat inside
ip virtual-reassembly in
ip igmp join-group 224.17.2.148
ip igmp join-group 224.17.1.148
ip igmp join-group 224.1.1.1
duplex auto
speed 100
!
interface Virtual-PPP3
no ip address
!
interface Virtual-Template1
ip unnumbered GigabitEthernet0/0
ip pim dense-mode
ip nat inside
ip virtual-reassembly in
ip igmp join-group 224.100.100.100
peer default ip address pool PPTP
no keepalive
ppp encrypt mppe 128
ppp authentication ms-chap ms-chap-v2 DRVIRUS
ppp authorization DRVIRUS
!
interface vmi3
no ip address
mode bypass
!
!
!
router eigrp 1
network 0.0.0.0
network 85.252.160.200 0.0.0.0
!
ip local pool PPTP 10.11.12.1 10.11.12.100
ip forward-protocol nd
!
ip nat inside source list INTERNET interface GigabitEthernet0/0 overload
ip nat inside source list NATPPTP interface GigabitEthernet0/0 overload
!
!
!
control-plane
!
!
!
!
mgcp profile default
!
!
!
!
!
gatekeeper
shutdown
!
!
!
line con 0
line aux 0
line 2
================================
03-31-2014 02:13 AM
i cant recive multicast on my pc , i mean when i run wireshark i only have heloo pim2 messages .
ive added eigrp for test , and i could reciver 224.0.0.10 from router.
but i want somebody expert to have a look on my config above and make sure it is correct to send & recive multicast packets
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide