03-05-2013 02:52 AM - edited 03-07-2019 12:03 PM
Hi,
I have WS-C2960-48PST-L Cisco POE switch, I have configured all of port in single vlan and connected Cmaera in all port.
Problam is some of port is showing "POER-DENY", and Camera is nt getting power from POE switch, but when I am removing or disconnected one of the on port then other port camera can be on and get power,
I think its power consuption issue, can I get some solution to make all camera on .
Please help...
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Fa0/17 auto on 15.4 Ieee PD 0 15.4
Fa0/18 auto on 15.4 Ieee PD 0 15.4
Fa0/19 auto power-deny 0.0 n/a n/a 15.4
Solved! Go to Solution.
03-05-2013 05:05 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
You might be over the PoE capacity of that switch, which is:
Cisco Catalyst 2960-48PST-L | N/A | 24 ports up to 15.4W | 370W |
03-05-2013 02:58 AM
Can you post the output to the command "sh run int f0/19"?
03-05-2013 05:05 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
You might be over the PoE capacity of that switch, which is:
Cisco Catalyst 2960-48PST-L | N/A | 24 ports up to 15.4W | 370W |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide