Port Channel on Fiber and Ethernet Interfaces

[D Prasanna Kumar Reddy]

Hello All,

Can we configure Single Port Channel on Fiber and Ethernet Interfaces ?

I think "YES", Could someone please confirm ?

Thanks,

Prasanna Kumar Desireddy

[Leo Laohoo]

I think you need to read this: Cisco EtherChannel Technology

[ahmedshoaib]

Hi, 

UTP & Fiber both are Ethernet technology, only difference is layer 1 physical media where actual traffic/data flow.

You can configure the port-channel on UTP & Fiber at same time in case all parameters should be same (I.e port speed, duplex settings & etc). If any parameter mismatched the port will not create port channel.

Thanks & Best regards.