Re: Port Forwarding. Please help

Jossnaz321 · ‎12-04-2006

Hello

I'm looking for a guide to do port forwarding with the pix 501.

Well here is what I've done so far:

I tried to add a translation rule to forward the port 7895 to the ip address 192.168.1.3

I used

static (inside,outside) tcp 84.73.34.77 7895 192.168.1.3 7895 netmask 255.255.255.255

and then i got it like this

But as soon as I try to click on this rule and change something, lets say the port number i get an error, saying I'm in conflict with the older given rule:

I read that I have to add an access list too. I've done that by writing

access-group outside-inbound in interface outside

access-list outside-inbound permit tcp any host 84.73.34.77 eq 7995

my access rules look like this:

img src="http://www.bildercache.de/bild/20061130-180133-61.gif" alt="" border="0" /> <br />

What did I do wrong? I'm very frustrated and hope someone can help me

thanks

sourabhagarwal · ‎12-04-2006

Hi,

hope this URL will help you.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708b4.shtml#t10

rate if it does ....

Jossnaz321 · ‎12-04-2006

hi

thanks a lot for the answer

Well, i still have the problem

As I mentioned and shown in the picture, there is a rule conflicting with the rule I want to add.

if I remove the other rule the internetconnection fails totally. I have to do some testing too but i'll rate you as soon as I got it and I hope thats soon.

I added the rule and the other rule is below which is conflicting.

"http://www.bildercache.de/bild/20061130-171046-93.gif"

but get the error

"http://www.bildercache.de/bild/20061130-171008-94.gif"

greetings

Jossnaz321 · ‎12-08-2006

I got the problem solved

and as I think a picture says more than 100 commands.

For port forwarding forward redirect redirection with cisco pix 501 using pdm you do as in the pictures attached.

I forwarded port 15177 in this example. You can use it to get a good id with bittorrent emule. No more low id, fast transfer now.

in translation rules open the wanted port and in access rules add a rule allowing any port to the ip.