04-02-2013 03:58 AM - edited 03-07-2019 12:35 PM
Hello,
I'm trying to test port-security in my c3550 but when I show port-security int f0/23 shows it only "Disabled" as below:
sh run
interface FastEthernet0/23
switchport access vlan 200
switchport mode dynamic desirable
switchport port-security mac-address sticky
spanning-tree portfast
Top#sh port-security int f0/23
Port Security : Disabled
Port Status : Secure-down
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 1
Total MAC Addresses : 0
Configured MAC Addresses : 0
Sticky MAC Addresses : 0
Last Source Address:Vlan : 0000.0000.0000:0
Security Violation Count : 0
I believe it should appear as Enabled is that correct?
Thanks
Solved! Go to Solution.
04-02-2013 04:07 AM
Hi Rod,
To enable/ disable port security on an interface, use the below form of this command.
switchport port-security
no switchport port-security
http://www.cisco.com/en/US/docs/ios/security/command/reference/sec_s6.html
2-
http://vashal.hubpages.com/hub/How-To-EnableDisable-Port-Security-On-A-Cisco-Switch
HTH
Regards
Inayath
*Plz rate the usefull posts.
04-02-2013 04:07 AM
Hi Rod,
To enable/ disable port security on an interface, use the below form of this command.
switchport port-security
no switchport port-security
http://www.cisco.com/en/US/docs/ios/security/command/reference/sec_s6.html
2-
http://vashal.hubpages.com/hub/How-To-EnableDisable-Port-Security-On-A-Cisco-Switch
HTH
Regards
Inayath
*Plz rate the usefull posts.
04-02-2013 04:14 AM
Hi Inayath,
Thanks so much!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide