cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2327
Views
0
Helpful
1
Replies

Port security with Access Points connected

sprocket10
Level 2
Level 2

We have a site where we are using Meraki access points. The problem we are having is that some users keep disconnecting the APs to hard wire into the wall port. Am I right in thinking that I cannot use port security on the switch for these ports as we have APs connected, as restricting the port to the mac address of the AP will stop everyone connecting. If this is right, what options do we have apart from gluing the cable into the wall point.

1 Accepted Solution

Accepted Solutions

Zach S
Level 1
Level 1

The easiest way to solve your problem is to get a locking cable or walljack enclosure. A lot manufacturers make them, one of the common designs requires a shaped key to release the RJ-45 jack; or if you don't mind redoing the walljack after someone rips it out you could glue it.

Example:
http://www.blackbox.com/Store/lp/LockPORT.aspx?utm_source=Redirect&utm_medium=BlackBox&utm_campaign=LockPort

View solution in original post

1 Reply 1

Zach S
Level 1
Level 1

The easiest way to solve your problem is to get a locking cable or walljack enclosure. A lot manufacturers make them, one of the common designs requires a shaped key to release the RJ-45 jack; or if you don't mind redoing the walljack after someone rips it out you could glue it.

Example:
http://www.blackbox.com/Store/lp/LockPORT.aspx?utm_source=Redirect&utm_medium=BlackBox&utm_campaign=LockPort

Review Cisco Networking for a $25 gift card