cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
174
Views
5
Helpful
1
Replies

PortChannel config isn't writing to all etherchannel interfaces

hvctorgamez
Beginner
Beginner

Good day and thank you for reading!

I have a small question, I created port channels, written the configurations, and assigned them to their specific interfaces. For some reason it's not passing through to the other interfaces. Everything seems to have worked as only half of the configurations didn't get their config.

Maybe one of you experts can enlighten this rookie!

Attached are the images and any help/information would be greatly appreciated-

hvctorgamez_0-1670281599193.png

Each portchannel config written out and assigned to their specific interfaces-

hvctorgamez_1-1670281665114.png

Channel-Group was made active on each interface-

hvctorgamez_2-1670281691595.png

But it didn't pass on to every interface-

hvctorgamez_3-1670281709539.png

Thank you!

 

 

 

 

 

1 Reply 1

I think you need first to 
switchport mode trunk 
then 
switchport trunk allowed vlan ........

to check 
show interface x switchport 

check if the interface is Operational  trunk not access 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers