portfast?

[starmantwo]

On a 2960...what is the command to show if portfast is enable on the ports?

[lejoe.thomas]

Hi

int interface-id

spanning-tree portfast

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_46_se/configuration/guide/swstpopt.html#wp1100483

HTH

Lejoe

[starmantwo]

thanks for reply but i know how to put a port on portfast...i just wanted to know if there was any sh commands to display ports in portfast. Rather than doing a sh run...

[lejoe.thomas]

Hi,

Sorry about that, no its just the show run to verify.

Edit|

show spanning tree interface | in PortFast

[Mark Yeates]

Hi Lejoe,

I thought of that at first, but doing that will only show lines spanning-tree portfast and nothing more. It will not indicate which ports it is configured on.

Mark

[Mark Yeates]

Jeff,

You can use the "show spanning-tree interface faX/X detail" command. It will show portfast is enabled or disabled. I don't know of a command that will quickly display all the ports of a switch that are configured for portfast.

HTH,

Mark