04-17-2006 10:09 PM - edited 03-05-2019 11:51 AM
I have a Catalyst 2950 series 12 prt. switch. When the switch is booting I receive the following error: "00:00:13: POST: Packet DA mismatch on port: 9"
What does this message means? Can I still use this port?
Kind regards,
Solved! Go to Solution.
04-19-2006 07:03 AM
Hi,
you might referece this link.
Peter
04-19-2006 05:42 AM
This is part of the power on self test(POST).
The switch sets the interface to loopback and sends
a packet. If anything is wrong or changed with
the packet then you get an error. In this case
the DA (destination address) was changed on
the received packet. I assume since this is a
switch they are referring to the layer2 address.
I would think this would indicate a possible hardware
failure.
04-19-2006 10:16 PM
Hi Nabib,
Thanks for the information.
I thought also that this is a hardware issue.
Thanks again
04-19-2006 10:18 PM
Hi Nabib,
Thanks for the information.
I thought also that this is a hardware issue.
Thanks again
04-19-2006 10:18 PM
Hi Nabib,
Thanks for the information.
I thought also that this is a hardware issue.
Thanks again
04-19-2006 07:03 AM
Hi,
you might referece this link.
Peter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: