Power over Ethernet - OID

[jakubgm]

Hi,

I'm trying to obtain values from the command output "show power inline police"

SW011#show power inline police

Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 370.0 360.0 10.0
2 370.0 340.7 29.3
3 67.0 0.0 67.0
Interface    Admin    Oper           Admin        Oper           Cutoff   Oper
                 State         State       Police        Police           Power  Power
--------- ------ ---------- ---------- ---------- ------ -----
Gi1/0/1 auto on none n/a n/a 4.4
Gi1/0/2 auto on none n/a n/a 3.5
Gi1/0/3 auto on none n/a n/a 4.4
Gi1/0/4 auto on none n/a n/a 4.0
Gi1/0/5 auto on none n/a n/a 5.0
Gi1/0/6 auto on none n/a n/a 3.5
Gi1/0/7 auto on none n/a n/a 3.3
Gi1/0/8 auto on none n/a n/a 3.7
Gi1/0/9 auto on none n/a n/a 3.6
Gi1/0/10 auto on none n/a n/a 3.7
Gi1/0/11 auto on none n/a n/a 3.8
Gi1/0/12 auto on none n/a n/a 4.3
Gi1/0/13 auto on none n/a n/a 3.9

I was able to get the value of

Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 370.0 360.0 10.0
2 370.0 340.7 29.3
3 67.0 0.0 67.0

But i'm not able to find in MiB the "oper power" value. Do someone know the OID for that and how to calculate the value if its not an integer?

[balaji.bandi]

check below document :

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-2960-series-switches/200371-Mismatching-consumed-power-inline-valu.html

[jakubgm]

Hi,

read it already but as understood the OID return only: "Available: Used: Remaining:" value and looking for the value from port individual consumption 

[balaji.bandi]

Not that i know that worked for me before, instead i run the script and get the output and make NMS to use that values based on the input (bit if pain work, but that works)

[jakubgm]

Yeah, me too.

Run python script that log into switch, run command "show power inline police" and parse the output.

SNMP will be simplier but as long as i cannot find the operation power by interface is useless for me.

The MIB https://www.circitor.fr/Mibs/Html/P/POWER-ETHERNET-MIB.php => also does not show to me operation power by interface. Only Module / Available / Used  / Remaining in total