- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 02:41 AM - edited 03-08-2019 01:11 PM
Hi community,
My switch WS3850-24XS-S can't power on after remove from the stack. The switch only boot when I connect the stack cables (power and data) or when I connect the second power supply.
I want to power on my switch standalone without stack, when I plug the power cable the switch start but no light on front only on the back (the fan light)
Any idea how can I start the switch without dual power or stack?
Thank you
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 02:51 AM
PWR-C1-715WAC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 02:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 02:51 AM
PWR-C1-715WAC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 02:53 AM - edited 12-21-2017 02:55 AM
What exact firmware is the stack running on?
But it sounds like CSCuz89095.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 03:01 AM
I have 3 WS3850-24XS-S, both have a 715W power supply and one have a 350W power supply, I saw now when u mentioned about the power. Now both switch start in standalone mode with 715W power supply. When I insert the 350W power supply alone the start but not booting, no light appear. seems like a mismatch devices from the fabric.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 03:16 AM
Yes minimum voltage require is 715W, the switch is brand new I remove from the box how can come with 350W power supply. maybe is a mistake from the fabric and I run around thinking that is an stack issue.
Thanks for your support.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2017 03:21 AM
@denilson.mota wrote:
how can come with 350W power supply.
Check the BoM or purchase order.
Someone needs to "override" this selection in CCW.
