05-15-2019 09:10 PM
hi team,
while i am configuring cisco router with pppoe protocol enable, i am getting following error,
Term-Server-7(config-vpdn-acc-in)#protocol pppoe
^
% Invalid input detected at '^' marker.
Term-Server-7(config-vpdn-acc-in)#
Term-Server-7(config-vpdn-acc-in)#protocol ?
any Use any protocol
l2tp Use L2TP
pptp Use PPTP
how can i enable this command,
regards,
Yasmeen
05-16-2019 06:41 AM
you are at the wrong configuration level?
look at this thread PPPoE Client-Server setup and configuration
05-16-2019 06:51 AM
also check the license
as in this thread PPPOE Server : Also note you will need a "data" licence (now called an "AX" licence) to make it work
05-16-2019 07:39 AM
Duplicate posts - to save confusion please remove this or the others
https://community.cisco.com/t5/switching/pppoe-server-configuration-on-cisco-router-2901-issues/m-p/3857233
https://community.cisco.com/t5/routing/pppoe-server-setup-and-configuration-router-2901/m-p/3857322
05-16-2019 10:26 AM
hi team,
my topology like below
cisco 2901 router ------> cisco switch ----> windows laptop
(PPPoe server) (PPPoe client)
i have configured commands, what shared in post,
the client pppoe getting ip address in pppoe connection but my issue i am unable to access internet
in last thread some one person shared me NAT config and ip access list config
but this is not worked on my setup
pls help me to complete my pppoe client internet access.
kindly share the same.
thanks,
Regards,
Yasmeen Shaul Hameed
05-16-2019 11:46 AM - edited 05-16-2019 11:52 AM
Hello Yasmeen,
I am the one that suggested NAT configuration of course it can contain errors.
My guess is that an extended ACL like ACL 101 is not supported on command
ip nat inside source list 101 interface dialer1 overload
The command may support only normal ACLs.
I apologize for this error
However, you can use the following
route-map NAT pemit 10
match addres 101
then use
ip nat inside source ruote-map NAT interface Dialer1 overload
In this wat you should be able to use the extended ACL with NAT.
I checked the syntax over the following configuration guide
Alternatively you can use a normal ACL
like
access-list 11 permit 10.222.222.0 0.0.0.127
+
ip nat inside source list 11 interface Dialer1 overload
Hope to help
Giuseppe
05-22-2019 05:30 AM
05-22-2019 05:43 AM
Hello Yasmeen,
I am happy that you have been able to fix the NAT configuration of your lab.
Have you used a standard ACL with NAT or a route-map and an extended ACL? Just to track.
Best Regards
Giuseppe
05-23-2019 07:20 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide