I am having problems getting Vlan's and routing to work correctly on a Cisco SG300-10MP switch for an IP Phone and Data system.
System is operational but devices on subnet 1 cannot access subnet 2 and subnet 2 cannot access subnet 1.
I have tried several configurations without success, please help with correct settings.
Primary Switch: SG300-10MP
Host Name: SG300-10MP
Mode: Layer 3
Vlan 1: 192.168.1.42 255.255.255.0
Vlan 2: 192.168.2.42 255.255.255.0
Ports 1 - 8: IP Phone + Desktop PC
Port 9: Link to Phone Switch (SG200-8 Smart Switch)
Port 10: Link to Data Switch (Linksys WRVS 4400 Gigabit Router)
Phone Switch: SG200-8
Host Name: SG200-8
Mode: Layer 2
IP Address: 192.168.2.41 255.255.255.0
Port 1: Phone Controller & DHCP 192.168.2.1 DHCP Range 192.168.2.100 - 200
Port 2: PhyBridge Server 192.168.2.5 24 x IP Phones + Desktop PC
Port 3: Phone Application Virtual Host 192.168.1.31
Virtual Phone Application Server 192.168.2.32
Port 4: Phone Maintenance workstation 192.168.1.101
Ports 5 - 7 Spare
Port 8: Link to Primary Switch (SG300-10MP) Port 9:
Data Switch: WRVS 4400N Gigabit Router (DHCP Server and Gateway to Internet)
Host Name: WRVS4400N
IP Address: 192.168.1.254
DHCP Range: 192.1678.1.100 - 250
Port 1: File Server: 192.168.1.13
Port 2: Exchange Server 192.168.1.15
Port 3: Web Server: 192.168.1.16
Port 4: Link to Primary Switch (SG300-10MP) Port 10:
WAN Port: Internet Service
Requirements;
All Desktop PC and workstations to have access to any device on Vlan 1 and Internet Gateway
All PC's must be able to access Virtual Application Server (192.168.2.32)
All IP Phones to have access to all devices on Vlan 2
Phone Controller must have access to Internet Gateway (192.168.1.254)
Phone Application Virtual Host must have access to Internet Gateway (192.168.1.254)
Remote maintenance must have access via Internet Gateway to Phone Controller (192.168.2.1) and Phone Application Server (192.168.2.32)
Any suggestions greatly appreciated.
Richard
