04-17-2019 05:30 AM
Hi Guys
I don't have allot of experience with ASR's first time deploying one of these. we have mainly been using ME3400 Switches as our Customer CE's.
Our client is deploying a small office and we need to tunnell all client vlans across the provider network(L2)
below is how we usually configure ME switches.
!
interface gi0/1
Description Customer Switch
switchport access vlan XX
switchport mode dot1q-tunnel
l2protocol-tunnel cdp
I have read few cisco articles but i am unsure if i am on the right track, below is my config on the ASR customer facing interface. Please advise , appreciate the help.
!
interface BDI30
description Customer1
no ip address
!
interface GigabitEthernet0/0/4
description Customer1 Switch
no ip address
media-type auto-select
negotiation auto
dot1q tunneling ethertype 0x9100
service instance 30 ethernet
encapsulation dot1q 30 second-dot1q 1-4094
rewrite ingress tag pop 1 symmetric
l2protocol tunnel cdp stp vtp
bridge-domain 30 split-horizon group 0
!
Thank you
Solved! Go to Solution.
04-29-2019 04:44 AM
Just an FYI, got it working .
mtu 9216
no ip address
media-type auto-select
negotiation auto
cdp enable
service instance 30 ethernet
encapsulation dot1q 1-4092
l2protocol forward cdp stp vtp
bridge-domain 30
04-29-2019 04:44 AM
Just an FYI, got it working .
mtu 9216
no ip address
media-type auto-select
negotiation auto
cdp enable
service instance 30 ethernet
encapsulation dot1q 1-4092
l2protocol forward cdp stp vtp
bridge-domain 30
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide