12-03-2008 08:20 PM - edited 03-06-2019 02:48 AM
Hi,
I am new to QoS and would like to setup auto QoS between my site and another site. Below is what I intend to implement on my switch (Cisco 6506-e) SUP720. Is this good enough?
switch(config)#mls qos
switch(config)#mls qos map cos-dscp 0 8 16 24 32 46 48 54
!
switch(config-if)#ip address x.x.x.x/30
switch(config-if)#mls qos trust cos
!
Solved! Go to Solution.
12-04-2008 01:21 AM
Hi,
One suggestion for change:
Instead of mls qos trust cos, do mls qos trust dscp
As CoS is only sent in 802.1q header (i.e. a trunked interface), it won't work. Trusting DSCP will work perfectly for L3 interfaces.
Other than that, what you have there is fine for a basic config.
12-04-2008 01:21 AM
Hi,
One suggestion for change:
Instead of mls qos trust cos, do mls qos trust dscp
As CoS is only sent in 802.1q header (i.e. a trunked interface), it won't work. Trusting DSCP will work perfectly for L3 interfaces.
Other than that, what you have there is fine for a basic config.
12-04-2008 05:42 AM
thanks much for the quick reply.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: